The MSA 6” Chisel Grip Tool Holder is built to fit on the shaft of up to 1” diameter, sledge-driven tools in order to put distance between your hand and the tool.

Build

This tool holder grips onto the shaft of a chisel in order to provide the user with a side handle to hold, therefore keeping their hand away from possible striking injuries.

Get extra leverage and control with this handle that is made of thermoplastic elastomer over-molded on high-density ABS plastic and with the high tensile fiber molded in rubber grip band that won’t creep or loosen grip with repeated blows.

The ergonomic, rubber grip design prevents slipping or turning in gloved or slippery hands.

A powerful grip on the tool being held!

How to Use

• Loosen knob on the bottom of the handle, allowing slack in tool strap
• Pull on tool strap to gain some slack in the strap
• Place tool into tool holder so that the tool is inside strap
• While holding the tool in place, tighten strap by twisting knob in a clockwise direction until the tool is securely in place.

Certifications, Standards, and Regulations

• OSHA Standards
• ANSI Standards